• Home
    • >
    • Resources/Instructions

resources

instructions

instructions

  • How to use Lunax Oil Lamp:
    • ● Before using the Lunax Oil Lamp for the first time, check if all parts are operational and free from damage.
    • ● Make sure that the wick length is sufficient, and the lower end is placed at the bottom of the tank.
    • ● When you fill up the lamp after a long time inactivity, or after wick replacement, allow 30 minutes to the wick to absorb fuel before lighting.
    • ● Always use Raimbow Lamp Oil.
    • ● Always place the oil lamp on a firm, robust and non-flammable surface.
    • ● Always allow the lamp to cool down before cleaning or taking away.
    • ● Keep it away from children and animals.
    • ● Do not leave the burning lamp unattended.
  • Filling and Wick Setting:
    • ● Fill the tank with Raimbow Lamp Oil to within 1 cm of top of the tank. Do not over fill.
      Wipe any spilled fuel from around the tank cap. Wick should not protrude more than 2mm above the tip of the nozzle to ensure it omits white light.
      Too long a wick may causes a large frame and lampshade overheating, which may lead to lampshade fracture.
  • Flame Adjustment:
    • ● Flame height should be adjusted to not exceeding 1 cm.
      Extinguish the flame by blowing it out. Do not try to make the flame length taller than the above by pulling up more wick.
  • Wicks:
    • ● Lunax Oil Lamp is equipped with the high-quality wicking.
      During the first several uses, the cotton cover of the wick will burn away, leaving the permanent element of the wick exposed.
      This permanent tip will not burn away, giving you a constant flame setting use after use.

TOP